The Pro-C controller is equipped with a delay between stations function. This feature allows the user to select a time delay between the end of one station run time and the start of another station's run time. The delay can be as short as a one second or up to 4 hours. The delay is a convenient feature when working with slow closing valves or slow well water recovery.
Programmable Delay Between Stations
- Start with the dial in the RUN position
- Press and hold the button down while turning the dial to the RUN TIMES position.
- Release the button. At this point the display will show a delay time for all stations in seconds, which will be blinking. The DELAY icon shall also be lit at this time.
- Press the and buttons to increase or decrease the delay time between 0 and 59 seconds in 1 second increments and then in one minute increments up to four hours. Hr will be displayed when the delay changes from seconds to minutes and hours. To remove a delay between stations, press the button to change the delay time to SEC: 00. The delay will no longer be active.
- Return the dial to the RUN position.
NOTE: The Master Valve/Pump Start circuit will operate during the first 15 seconds of any programmed delay to aid in the closing of the valve and to avoid unnecessary cycling of the pump.