TTS-800 Golf Rotors - Service and Maintenance - Riser Assembly Removal and Installation

WARNING: Ensure the selector switch is in the OFF position before removing the internal riser assembly.

NOTE: Notice that the selector switch is raised above the lid surface when in the manual OFF position.

1

Use the snap ring removal tool (P/N 251000SP) or a flathead screwdriver to turn the selector switch to the OFF position.

 

2

Insert the end of of the snap ring removal tool into the slot in the snap ring and pull up to remove the snap ring.

 

3

Insert the end of the snap ring removal tool into the slot in the riser logo cap and turn to engage. Then pull up to remove the internal riser assembly.

 

4

Turn the quarter-turn screw counterclockwise to release the lid. Insert the snap ring removal tool (P/N 251000SP) or a flathead screwdriver into the slot on the side of the lid and pry up to remove.

5

Push the tabs on the back of the yardage marker to remove it from the lid.

 

Ti serve ancora aiuto? Siamo qui per te.

Dicci di cosa hai bisogno e troveremo la soluzione migliore per te.

Contatta l'assistenza