How do I program or remove a delay between stations on my Pro-C controller?

Programmable Delay Between Stations

This feature allows the user to insert a delay between when one station turns off and the next station turns on. This is very helpful on systems with slow closing valves or on pump systems that are operating near maximum flow or have slow well recovery.

1. Start with the dial in the RUN position.
2. Press and hold the 
   
     button down while turning the dial to the SET STATION RUN TIMES position.
3. Release the 
   
     button. At this point the display will show a delay time for all stations in seconds, which will be blinking. The DELAY icon shall also be lit at this time.
4. Press the 
   
     and 
   
     buttons to increase or decrease the delay time between 0 and 59 seconds in 1 second increments and then in one minute increments up to four hours. Hr will be displayed when the delay changes from seconds to minutes and hours. To remove a delay between stations, press the 
   
     button to change the delay time to SEC: 0. The delay will no longer be active.
5. Return the dial to the RUN position.

NOTE: The Master Valve/Pump Start circuit will operate during the first 15 seconds of any programmed delay to aid in the closing of the valve and to avoid unnecessary cycling of the pump.