EZDS - Installing the EZ-DM

If the whole system is two-wire, install the EZ-DM module in the first slot in the controller. Press the Reset button on the back of the controller face panel to recognize the new module.

A - P/MV (Pump/Master Valve): Connects to P/MV on power module ONLY if decoder will be used for P/MV

B - Program button and status LED

C - Two-Wire path terminals (two paths available)

D - Decoder Programming Port: Insert decoder red and blue wires for programming

1
  • Open blue lock lever.
  • Insert module tabs into end of slot, and tip into place.
2

Close locking lever

3

Press controller Reset button. Controller will then recognize the new module, and the controller size will change to 54 stations.

EZ-DM may also be combined with ICM-800 and ICM-400 modules for "hybrid" operation. They can use "conventional" solenoid wiring and two-wire technology at the same time, up to 54 stations maximum. It is recommended to install all conventional modules in the lower-numbered slots, and install the EZ-DM in the next available slot.

  • The conventional modules will operate the station numbers that are shown on the backplane of the controller, next to the slot.
  • The EZ-DM module can operate remaining station numbers up to 54 via the two-wire paths.
  • Do not program duplicate station numbers when combining conventional modules and the EZ-DM. If an EZ decoder is programmed to station 1, and there is a conventional module in the first output slot with station 1, both station "ones" will turn on at the same time. This may cause a station error if it causes an overloaded current condition.
  • Only program decoder station numbers that are not in use on conventional output modules.

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support

Find Hunter