Wind-Clik Support

Welcome to the wind-clik senor support section. The wind-clik will interrupt irrigation if wind speed is too high. In this section you will find information on how to install, adjust and wire the Hunter wind-clik sensor

  • Introduction
    In most installations, the Wind-Clik acts as a switch to break the circuit to the solenoid valves of the irrigation system during high wind conditions. This allows the timer to
  • Mounting
    The housing of the Wind-Clik is designed to slip over the end of 2" PVC pipe. The length and the fixing of the pipe is then up to the user depending on the situation. For example,
  • Wiring
    The Wind-Clik connects directly to the X2, X-Core®, XC Hybrid, Pro-C®, ICC2, I-Core®, ACC, ACC2, and Hydrawise® controllers. This allows you to easily override the sensor by using
  • Adjustments
    The large knob is the switching (actuation) speed in mph. For example, if the unit is wired “normally closed,” the dial will indicate the wind speed that the unit will switch open.
  • Operation
    There is built in damping in the unit to alleviate the problem of short gusts of wind. Therefore, the wind speed settings, while accurate under controlled conditions, are actually

Find Hunter