Welcome Page Body
The EZ Decoder System (EZDS) is a unique two-wire output option for Hunter ICC2 and HCC controller models only. The EZ Decoder System significantly reduces installation costs on larger systems and allows for simple expansion of projects as needs change.
Section Menu
Overview
-
Overview
The EZ Decoder System is a unique two-wire output option for Hunter ICC2 and HCC controller models only. Do not attempt to use this system with any other model or brand of
Handheld Wireless Diagnostic Tool
Installation
-
Installing the EZ-DM
If the whole system will be two-wire, install the EZ-DM module in the first slot in the controller. Press the Reset button on the back of the controller face panel for the new
-
EZ-DM Connections
A - P/MV (Pump/Master Valve): Connects to P/MV on power module ONLY if decoder will be used for P/MV B - Program button and status LED C - Two-Wire path terminals
-
Two-Wire Path Connections and Rules
The output of the EZ-DM wire paths is 24VAC, 50/60 Hz. Voltage is only present on the paths when stations are active. The red and blue wire path terminals on the EZ-DM indicate
-
Universal Two-Wire Decoder Staking kit
The DECODER STAKE raises the decoder off the ground to provide easy access for wireless programming tools (ICD-HP & EZ-DT) during routine maintenance, keep wiring and connections
Operation
-
Operation
EZ Decoders do not require special operating procedures, and the programmed decoders will operate exactly like conventionally-wired stations. When a decoder station begins to
Troubleshooting
-
Troubleshooting
Symptom Possible Causes Corrective Action A red light on decoder module Shorted decoder/solenoid or bad connection to
Compliance Information
-
Compliance Information
FCC Notice This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instruction manual, may
Updating Firmware
-
Updating Firmware
If new firmware versions are released for any of these components, the files can be downloaded to your computer using the links below. They can be uploaded to the EZ-DT via a