Freeze-Clik Support

Welcome to the Freeze-Clik sensor support section. The freeze-clik will turn off irrigation in freezing conditions. In this section you will find information on how to install and wire the Freeze-Clik sensor.

  • Introduction
    Note: Both the standard Freeze-Clik and the Freeze-Clik-Rev (a “reverse” model where instead of switching system operation “off” at a set temperature point, the system is switched
  • Wiring
    Wiring to the X-Core Controller The Freeze-Clik connects directly to the X-Core or XC. This allows you to easily override the sensor by using the Sensor switch on the front
  • Bypassing Sensor
    All current Hunter controllers are equipped with a built-in bypass that allows you to override an active sensor. For controllers not equipped with this feature, should you desire

Find Hunter