Wind-Clik - Wiring

X-Core Controller
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

 

 

Pro-C Controller PC-400 (2014 or newer)
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

Pro-C Controller PC300 (Older than 2014)
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

HC Controller
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

PRO-HC Controller
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

 

 

 

I-Core / ACC2 Controllers
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

ICC2 Controllers
  1. Remove the sensor jumper across the two SEN terminals in the controller.
  2. Attach the GREEN wire to one SEN terminal and the RED wire to the other SEN terminal.
  3. The BLUE wire is not used for installation on Hunter controllers.

 

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support