Flow-Sync - Components

Installation Procedures

This section will give you a brief overview of some of the components of the Flow-Sync system.

A. Flow-Sync Sensor (HFS Series)

  1. Impeller: Rotates when flow is occurring

  2. O-rings: Provides sealing of sensor in sensor body

  3. Wires: Black and red wires connect sensor to the ACC or I-Core controller

Note: Black and Red wires must be wired to correct black/red terminals in controller.

B. Flow-Sync Body (FCT Series)

  1. Flow-Clik Tee (FCT): The Tee is installed into the irrigation system and houses the Flow-Sync

  2. Plug (replace with Flow-Sync at installation)*

  3. O-rings: Provides sealing of plug in sensor body

  4. Cap: Retains plug or sensor in sensor body

  5. Cover: Snaps over the top of the sensor

Note: FCT Tees are ordered for the desired pipe diameter separately from the Flow-Sync.

*For areas that require Winterization of irrigation systems, save the plug for winterization.

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support

Find Hunter