X-Core Support

  • Components
    LCD Display (both Indoor & Outdoor Models)Run Times: Allows user to set each valve station run time from 1 minute to 4 hoursStart Times: Allows 1 to 4 start times to be set in each
  • System Off
    Valves currently watering will be shut off after the dial is turned to the SYSTEM OFF position for two seconds. The display will be flashing OFF. All active programs are
  • Programmable Rain Off
  • Troubleshooting Overview
    Problem The controller is continuously watering Cause Too many start times have been programmed Solution
  • No AC
  • Controller Not Starting
    There are a number of reasons why the sprinklers may not come on. Below is a logical method of wading through the possible causes to isolate the problem:Check the Programming:Is
  • Station Repeats
    A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the
  • Sprinklers Not Watering
    There are three reasons why your sprinklers may not be watering:The most common reason your sprinklers are not watering is because the rain sensor is active. Do you have a rain
  • No Zones Running
  • Sprinkler Icon
    The sprinkler icon flashes when the controller is outputting power to the station terminal or terminals activating a station.If the icon is blinking with an umbrella on the display
  • Station Off
    To stop a station from running when the system cycles automatically, simply remove all station Run Times from Programs A, B, C and on some controllers Program D.Be sure to check
  • Maximum Solenoids per Output

Find Hunter