Pro-HC Support

Choose a suitable location with strong Wi-Fi coverage.Using a 3/ 16" drill bit, drill a hole and insert a plastic anchor.Insert a screw into the anchor, leaving 1/8" exposed.Slide

The Hydrawise app, short for "application," refers to the software program on a computing device, such as a smartphone, tablet, or computer, that allows you to interact with the

Start by choosing a location with good Wi-Fi coverage. Wi-Fi coverage can be easily tested using a smartphone. A signal strength of 2 or 3 bars is recommended. Wi-Fi connectivity

Indoor CabinetRoute the transformer cable through the hole on the bottom left side of the controller and connect one Yellow Wire to each of the screws marked 24 VAC and the Green

Route valve wires between control valve location and controller.At valves, attach a common wire to either solenoid wire of all valves. This is most commonly a white-colored wire.

Valve Wire Sizing (Maximum One-Way Distance in Feet Between Controller and Valve)Ground Wire SizeControl Wire (ft)Below is a chart indicating the maximum wire runs that can be used

The Pro-HC Controller supports most open/closed contact types of sensors. Compatible Hunter flow meters and sensors include the HC FLOW METER, MINI-CLIK®, RAIN-CLIK™, FREEZE-CLIK®,

We recommend that a qualified licensed contractor perform this type of winterization method. The blowout method utilizes an air compressor with a cubic foot per minute (CFM) rating

To access the serial number on the touch screen, follow these steps:From the HOME screen, click STATUS.Click CONNECTION STATUS (fig.1).The serial number is shown on this screen and

After entering your wireless settings the controller will connect to your access point. The connection process takes about 30 seconds. Upon successful connection the wireless