Soil-Clik Support

Welcome to the Soil-Clik support section. The Soil-Clik measures moisture in the soil and stops watering once soil reaches desired moisture level. In this section you will find instructions on connecting, installing, programing and troubleshooting the Soil-Clik sensor.

  • Specifications
    Soil-Clik is a soil moisture system that prevents overwatering when the soil is wet. Soil-Clik is designed for use with Hunter controllers that have normally-closed smart sensor
  • Choosing the Probe Location
    The moisture sensing Soil-Clik probe must be installed within 1000 ft (300 m) of the Soil-Clik module, using 18 AWG (1 mm2) Direct Burial (UF) wire. Choosing the Zone Install
  • Installing the Soil-Clik Probe
  • Connecting the Probe to the Module
    Use only 18 AWG (1 mm2) or larger direct burial rated wire, up to 1000 ft (300 m) from the module. Note: Avoid high voltage lines or other sources of electrical interference
  • Module Location
    The Soil-Clik module is designed for outdoor installation when necessary. However, electronics will benefit from a protected location when practical. Mount within 6 ft (2 m) of
  • Wire Overview
    Gray Wires: Connection to Soil-Clik Probe. Yellow Wires: Soil-Clik Module power, requires 24 V AC power (100 mA, max). White Wires: Module output, to Hunter controller sensor
  • X-Core®
    Yellow power wires to X-Core 24 VAC terminals. White wires to Sensor (SEN), or common interrupt. Gray wires to PROB.  
  • Pro-C®
    Yellow power wires to Pro-C AC1 and AC2. White wires to Sensor or common interrupt. Remove jumper plate from Sensor Terminals. Gray wires to PROB.
  • I-Core®
    Yellow power wires to I-Core AC1 and AC2. White wires to S1, S2 or S3 terminals. Remove jumper wire from selected Sensor Terminal. Gray wires to PROB.
  • ACC
    Yellow power wires to 24 VAC terminal and Com terminal. White wires to any unused sensor S1 through S4. Gray wires to PROB.
  • ICC2
    Yellow power wires to ICC2 AC1 and AC2. White wires to the sensor terminals. Remove jumper plate from Sensor Terminals. Gray wires to PROB.  
  • Common Interrupt
    Common Interrupt (most AC-powered controllers) Connect Yellow power wires to 24 VAC power in the controller. Cut field common wire(s), and splice one Soil-Clik White wire
  • Using Soil-Clik with Solar Sync®
    When paired together, the Hunter Solar Sync and Soil-Clik make the ultimate smart irrigation solution for your sprinkler system.  Solar Sync adjusts run times for weather
  • LCD Screen Callouts
    Soil-Clik is used to set a desired moisture level. The level may be changed with the + and - buttons. When the desired moisture has been reached, Soil-Clik will interrupt
  • Operation
    The bar steps in the display represent centibars of soil water tension on a scale of 10 to 100. High numbers indicate dry soil, or soil from which it is very difficult for plants
  • Troubleshooting
    Problem Plants are too dry. Cause Moisture level setting too low. Sensor in wrong location.

Find Hunter