The EZ-DT is a handheld, battery-operated device used for field diagnostics and troubleshooting with EZ Decoder Systems. Innovative wireless communication from the EZ-DT to EZ-1 decoders permits fault detection in the field without removing the decoders …

The radius of throw, or distance the water sprays, on Hunter spray nozzles can be adjusted by turning the center screw on top of the nozzle. All nozzles come from the factory in the fully open position. To reduce the radius, use a flathead screwdriver to …

Hunter adjustable nozzles come from the factory with a preset arc of 90°. Prior to setting the left-side edge of the spray pattern, set the right-side edge by ratcheting the riser assembly and aligning the right side of the spray pattern with the …

Centralus™ - A2C-WiFi - Configuration and Connection …

Centralus™ - A2C WiFi - Software Setup …

The  Hunter Adjustment Wrench  consists of a 3/32 Allen key, two convenient finger loops for gripping, and an opposite side arc adjustment key for all your Hunter rotor adjustments. The Hunter wrench can be purchased from your local distributor. You can …

Metal controllers will include a hole plug assembly in a pre-drilled factory hole on top of the controller. Remove the nut on the inside of the controller to remove the plug. Route the cable through the pre-drilled hole and the antenna nut. Then tighten …

Turn off the controller power using the power switch on the transformer. … Remove the dust cover, or existing module, from the bottom rear of the controller facepack. Push up on the spring-loaded button and pull downward to remove. Slide in the new module …

Adding the controller to the Centralus software will require a few simple steps. You must have a free Hunter SSO account to add a controller. Learn More NOTE: If you see the message DEVICE ALREADY CLAIMED , please get in touch with the original …

Turn off the controller power. Tilt and remove the facepack to access the bottom of the facepack. Remove the dust cover or prior module from the controller facepack. Press the spring-loaded button and pull downward to remove. Insert the new A2C-WIFI …

Use the  CONTROLLER OFF feature to stop manual/automatic watering commands, set programmable days off (1-180 days), and set the controller off. Sign in to your  C ENTRALUS ACCOUNT . Select a controller name from your  CONTROLLER LIST . Click on the …

After setting up an ACC2 or ICC2 controller in your Centralus account, you may choose to release the controller (serial number) to another user. This will require the controller's deletion. When the NEW user adds the controller into the Centralus …

When using Centralus Software, you have the ability to change your STATION , BLOCK , and/or DELAY RUN TIMES . There is a maximum run time of 12:00 hrs for all model A2C controllers.  The minimum run time is 15 seconds for the decoder model and 1 …

The  SETTINGS tab contains high-level information about the controller, plus Advanced settings that the controller will use in irrigation. Controller Information Address Network Information Date & Time Notifications Cycle & Soak Pump/Master Valve Setting …

If a customer claims and purchases a subscription for an A2C-LTE device and no longer wants to have ownership of the device, there is the option to cancel the subscription. When a customer cancels a subscription, the plan status will change to CANCELING …