P2C Support

All necessary hardware is included for indoor and outdoor installations. Use the hole at the top of the controller as a reference and secure a 1" (25 mm) screw into the wall.

P2C models are prewired with a power cord and plug for simple installations in both indoor and outdoor applications. If the controller is to be powered by direct line voltage,

The Pro-C Controller is supplied with a factory-installed base module for up to 4 stations. Additional modules may be added in increments of 3 stations (PCM-300), 9 stations (PCM

The P2C controller is supplied with a base 4-station module. The P2C is also compatible with the EZ Decoder System (EZDS) for hybrid conventional and two-wire operations. Add a

Route valve wires between control valve location and controller. At valves, attach a Common wire to either solenoid wire of all valves. This is most commonly a white wire.

Connect either wire from the Master Valve to the P/MV terminal on the 4-station base module. Connect remaining wire to the COM (Common) terminal.    

Route a wire pair from the pump relay into the controller housing. Connect the pump Common wire to the terminal slot COM (Common) and the remaining wire from the pump relay to

The P2C Controller is compatible with Hunter remote controls. The SmartPort Wiring Harness (included with all Hunter remotes) allows for fast and easy use of Hunter controls.

The P2C-400 can operate a lighting transformer equipped with the PXSYNC interface box. When using the P2C-400 to operate a lighting transformer, any available station terminal can

New Pro-C Controllers (P2C models) include two sensor inputs. The SEN-SEN terminals from the original Pro-C Controllers have been split into SEN and SEN-2 to allow for two separate

If the rain sensor is interrupting irrigation, you can bypass it by using the bypass switch on the front of the controller. Press the Sensor Bypass button to temporarily bypass the

Turn the dial to the DATE/TIME position. The current year will flash in the display. Use the + or - buttons to change the year. Push the → button to set the month. The month

Turn the dial to the START TIMES position. Press the PRG button to select A, B, or C. Use the + and - buttons to change the start time. (Advances in 15-minute increments.)

Turn the dial to the RUN TIMES position. The display will show the last program selected (A, B, or C) and the station number selected. The run time for that station will flash

Turn the dial to the WATER DAYS position. The display will show the last program selected (A, B, or C). You can switch to another program by pressing the PRG button. The

All stations have the P/MV start circuit ON in the default setting. To program P/MV operation:   Turn the dial to the PUMP position. Press the + or - buttons to toggle

Seasonal Adjust is used to make global run time changes without reprogramming the entire controller. Turn the dial to the SEASONAL ADJUST position. Press the + or - buttons

Valves currently watering will shut off after the dial is turned to the SYSTEM OFF position for two seconds. All active programs will be discontinued and watering will stop. To

This feature permits the user to stop all programmed irrigation for a designated period from 1 to 31 days. At the end of the programmable off period, the controller will resume

After programming is complete, turn the dial to the RUN position to enable automatic execution of all selected programs and start times.

Turn the dial to the MANUAL position. The station run time will flash in the display. Use the → button to move to the desired station. You may then use the + and - buttons to

You can also activate a program to water without using the dial. With the dial in the RUN position, hold down the → button for 2 seconds. This feature automatically