This function will allow you to test the connected solenoid operation using the local manual start button in the battery compartment.
- Remove the Battery Cap, and the retaining ring by turning counterclockwise.
- Press and hold the Manual Start Button (left) to start the first station (blue LED will light, and the solenoid will click if attached).
- Press again to Advance to the next station (If it is a multi-station controller).
- The Blue light will Blink rapidly to show which station output is active.
- After the last station starts (multi-station WVLs), press the Manual Start Button one more time to stop all test irrigation. The test function will stop after 1 minute if it does not receive further commands.
- Push the Battery Cap back on firmly, and tighten the retaining ring by hand to complete the installation. Make sure the large O-ring remains in place to seal the enclosure.
- Replace the Valve Box lid with the installed antenna and verify proper operation with a controller station start.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.