Pilot-IH - Field Wiring

Proper installation and connection of the two-way module two-wire paths is very important. To learn how to make a proper wire connection please watch the video below.

• Use only Hunter IDWIRE or an approved substitute.
• Use only Hunter DBRY-6 waterproof connectors in the red and blue two-wire path connections.
• Leave adequate slack (about 5' or 1.5 m) at each splice to prevent disconnection.

Each PILOTDH250 output module supports up to 250 two-way module stations.

• Each module allows up to six two-wire path connections.
• Each path may be up to 10,000' (3 km) with 14 AWG (2 mm²) wire or up to 15,000' (4.5 km) with 12 AWG (approximately 3.31 mm²) wire.
• Two-wire paths may be tee-spliced (in a valve box with approved connectors) as long as the maximum distance to each end of the paths from the controller does not exceed the maximum for the wire used.